Commercial Kitchen Equipment

CASTOR WITH BRAKE - CASTORWITHBRAKE - Two Castors Per Set

Three Door
7 × 1/3 × 150 mm GN pans**
Stainless Steel interior & exterior*

• 2 to 8°C
• fridge has one level of shelving plus floor
• tilted pans with easy-slide Perspex covers***
• Embraco compressors/li>
• German ËBM-Pabst fans
• Dixell digital temp. control & read-out
• Ambient 32ºC & 60% RH
• internal corners rounded for hygiene & easy cleaning
• insulation is CFC & HCFC free
• extremely efficient self-closing doors
• auto defrost • self evaporating drainage
• castors

  * gal metal back

  ** pans not included
  ** sliding pan covers must be used to ensure correct operating temperature

      Tops are holding units & product needs to be pre-chilled to less than 5ºC before filling

Stainless Steel interior & exterior*
GASTRONORM

Four glass doors
Matches GN series bench freezers

• 2 to 8°C
• one level of shelving plus floor
• Aspera or Zanussi compressors
• German ËBM-Pabst fans
• Italian (Carel) digital temp. controls & read-out
• Ambient 32ºC & 75% RH
• Units can be easily slid open for cleaning & maintenance
• internal corners rounded for hygiene & easy cleaning
• fan-forced evaporator cooling
• auto defrost
• self evaporating drainage
• insulation is CFC & HCFC free
• extremely efficient self-closing doors
• heated door frame
• 100mm wall clearance required for ventilation
• castors

  * gal metal back

Two Door
9 × 1/3 GN Poly pans (included)
Stainless Steel interior & exterior*

• 0 to 5°C
• fridge has one level of shelving plus floor
• tilted pans with section SS lids (pans included)**
• Aspera compressors
• German ËBM-Pabst fans
• Dixell digital temp. control & read-out
• Ambient 32ºC & 75% RH
• internal corners rounded for hygiene & easy cleaning
• PE cutting board included
• insulation is CFC & HCFC free
• extremely efficient self-closing doors
• auto defrost
• self evaporating drainage
• castors

  * gal metal back
  ** Pan lid must be utilised to ensure correct operating temperature

      Tops are holding units & product needs to be pre-chilled to less than 5ºC before filling